Step 2: Turn Off The Lights
If you need to adjust your headlights because they are too high or too low, please do the following steps:1) Turn off the headlight switch. 2) Unscrew the cap on top of the headlights. 3) Use a screwdriver to loosen and screw in one side at a time until it is in the desired position.
Image source: https://www.homedepot.com/
4) Put back together by tightening with screwdriver. 5) Turn on headlight switch to test if headlights are adjusted. If not, repeat steps 1-5 until light position is correct (should take less than 5 minutes). 6). Add any necessary silicone sealant around screws when complete (should only be needed for lights that rusted or old).
Image source: https://www.dell.com/
NOTE: If you have trouble screwing the cap back on, you can use an "open end" wrench to secure the cap from coming off and flying around.
Image source: https://www.croma.com/
***Also, if your headlights are too high, rotate your car so that it is facing a wall or fence (where you will then drive into the wall or fence). During this process, the headlights should be pointing further down so you can lower them.***
Image source: https://www.asus.com/
Our blog post today is about how to adjust your led projector headlights. You can find more information at our website or you can call our customer service number with any questions. One of the most important parts of owning an automobile is keeping your headlights in working order.
Image source: https://www.lg.com/
When it comes to vehicles, your headlight's job is pretty obvious: they help you see where you’re going when the sun goes down or when it starts to rain. They’re even useful for nighttime safety, as you can be seen from any distance with a regular set of headlights. However, if your lights are not functioning properly, you could be putting yourself and others at risk when driving.
Image source: https://epson.com/
The fact is that a poorly working set of lights can create quite a distraction while driving. According to the AAA Foundation for Traffic Safety, distracted drivers are four times more likely to cause an accident and 41 percent more likely to run off the road.
Image source: https://www.walmart.com/
There are several reasons why your headlight may not be working properly. One of the most common reasons is a broken bulb or lens. These parts are very delicate, however, and can be quite expensive to replace. Luckily, there are a few steps you can take in order to test your lights and make sure that they aren't broken before buying a replacement.
Image source: https://justinrange.com/
Step 1: Unplug The Headlamp Into The SideThe first step on how to adjust led projector headlights is to unplug your auto headlight from the car's electrical system. Find the side of the car that plugs into the battery, and then use a small screwdriver to disconnect it from the power source. When you see that your lights aren't working, it's time to take a look at the headlight to see if there's anything wrong with it.
Image source: https://www.amazon.com/
The next thing you want to do is turn off your headlights. This ensures that there is no voltage flowing through them, and it will make it easier for you to check them out more thoroughly. You can also remove the bulbs and inspect them for damage or any other disorder. However, most people will simply want to inspect the lens for cracks rather than completely remove the headlamps and bulbs from their cars.
Comments
Post a Comment